Gateron CAP Milky Yellow

Switches

Mounted without screws; instead, using a 1/10" layer of 40a Sorbothane under the PCB; it's tight but it just barely fits. I did this because the plate mounting points are not good on the original X60, so mounting it on Sorbothane evens everything out and adds a bit of gasket-like dampening (although not a lot due to the high compression).

* Plate: aluminum
* Stabilizers: pre-retool Cherry snap-in
* PCB: KBD6x (hotswap)
* Switches: stock (!!)

Discover

Gateron CAP Milky Yellow

Builds

Comments

Comments - 0

Keyboards

Pages

Social Media